JZR3-L8 Needle Valve Mud Pump Parts Forged Gardner Denver Mud Pump Parts

What is JZR3-L8 Needle Valve?

JZR3-L8 Needle Valve were use in Mud Pump Parts.with connection the pressure gauge, used in BOMCO Mud pump parts; Such as the F800;F1000;F1300;F1600;F200HL.

An instrument JZR3-L8 needle valve uses a tapered pin to gradually open a space for fine control of flow. The flow can be controlled and regulated with the use of a spindle. A needle valve has a relatively small orifice with a long, tapered seat, and a needle-shaped plunger on the end of a screw, which exactly fits the seat.

As the screw is turned and the plunger retracted, flow between the seat and the plunger is possible; however, until the plunger is completely retracted, the fluid flow is significantly impeded. Since it takes many turns of the fine-threaded screw to retract the plunger, precise regulation of the flow rate is easily possible.

JZR3-L8 needle Advantages:

· The virtue of the JZR3-L8 needle valve is from the vernier effect of the ratio between the needle's length and its diameter, or the difference in diameter between needle and seat.

· A long travel axially (the control input) makes for a very small and precise change radially (affecting the resultant flow).

· JZR3-L8 Needle valves may also be used in vacuum systems, when a precise control of gas flow is required, at low pressure,[1] such as when filling gas-filled vacuum tubes, gas lasers and similar devices.

JZR3-L8 Needle valves are usually used in flow-metering applications, especially when a constant, calibrated, low flow rate must be maintained for some time, such as the idle fuel flow in a carburettor.

Note that the float valve of a carburettor (controlling the fuel level within the carburettor) is not a needle valve, although it is commonly described as one. It uses a bluntly conical needle, but it seats against a square-edged seat rather than a matching cone.

The intention here is to obtain a well-defined seat between two narrow mating surfaces, giving firm shutoff of the flow from only a light float pressure.

JZR3-L8 Needle valves are also commonly used to provide shut off for the pressure gauge or on applicators to shut off the supply of NH3 to the knives in Anhydrous Ammonia (NH3) applications.